01-03-2018, 11:38 AM
Hallo,
I'm using pilight 8.0 on RPi3 with low-pass-filter. I'm sending a signal (INTERTECHNO protocol) genrated by an ATTINY85 / 433MHz-transmitter to the RPi. pilight does'nt detect / decode the signal apart from a few exceptions, while RCSwitch-RFSniffer / wirless sockets do not have any problems. When I do the same with an Arduino Nano all works pretty fine.
Are there minimum requirements for signal strength / waveform different from RCSwitch/wiringpi based in wiringx?
wupperpi
I'm using pilight 8.0 on RPi3 with low-pass-filter. I'm sending a signal (INTERTECHNO protocol) genrated by an ATTINY85 / 433MHz-transmitter to the RPi. pilight does'nt detect / decode the signal apart from a few exceptions, while RCSwitch-RFSniffer / wirless sockets do not have any problems. When I do the same with an Arduino Nano all works pretty fine.
Are there minimum requirements for signal strength / waveform different from RCSwitch/wiringpi based in wiringx?
wupperpi