03-19-2015, 07:32 PM
Great!
I have also tested this on my arduino nano v3, but i have the problem that i can't send with my 433mhz module, receiving works perfect with barely load on the daemon.
When i try to send something i do see the (i think rx) led light up on the arduino, so it seems to be fine on the pilight config side. The 433 module works fine with sending when using the gpio.
Are there some ways i can check what is going wrong?
I'm pretty sure i wired everything fine. The arduino is new though and i have no idea if pin D5 maybe is broken, can i check it on another port?
I have also tested this on my arduino nano v3, but i have the problem that i can't send with my 433mhz module, receiving works perfect with barely load on the daemon.
When i try to send something i do see the (i think rx) led light up on the arduino, so it seems to be fine on the pilight config side. The 433 module works fine with sending when using the gpio.
Are there some ways i can check what is going wrong?
I'm pretty sure i wired everything fine. The arduino is new though and i have no idea if pin D5 maybe is broken, can i check it on another port?