yes, i bought this device
http://www.amazon.de/gp/product/B00PL70X...ge_o05_s00
now i get
But LOG show
http://www.amazon.de/gp/product/B00PL70X...ge_o05_s00
now i get
Code:
pi@raspberrypi /etc/pilight $ sudo pilight-flash -f /etc/pilight/pilight_usb_nano.hex -p /dev/ttyUSB0
[Jun 23 19:01:29:752757] pilight-flash: INFO: **** START UPD. FW ****
[Jun 23 19:01:29:753521] pilight-flash: INFO: Indentifying microprocessor
[Jun 23 19:01:30:830160] pilight-flash: INFO: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.01s
[Jun 23 19:01:30:839294] pilight-flash: INFO: AVR device signature = 0x1e 0x95 0x0f
[Jun 23 19:01:30:843881] pilight-flash: INFO: Firmware running on an ATmega328P
[Jun 23 19:01:31:941773] pilight-flash: INFO: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.01s
[Jun 23 19:01:31:950802] pilight-flash: INFO: AVR device signature = 0x1e 0x95 0x0f
[Jun 23 19:01:31:958689] pilight-flash: INFO: AVR lfuse reads as 0
[Jun 23 19:01:31:967176] pilight-flash: INFO: AVR hfuse reads as 0
[Jun 23 19:01:31:967499] pilight-flash: INFO: AVR FLASH memory has been specified, an erase cycle will be performed
[Jun 23 19:01:31:967684] pilight-flash: INFO: AVR chip being erased
[Jun 23 19:01:31:977035] pilight-flash: INFO: reading input file "/etc/pilight/pilight_usb_nano.hex"
[Jun 23 19:01:31:977471] pilight-flash: INFO: input file /etc/pilight/pilight_usb_nano.hex auto detected as Intel Hex
[Jun 23 19:01:31:981060] pilight-flash: INFO: writing flash (4214 bytes)
Writing | ################################################## | 100% 1.18s
[Jun 23 19:01:33:158701] pilight-flash: INFO: 4214 bytes of flash written
[Jun 23 19:01:33:179477] pilight-flash: INFO: verifying flash memory against /etc/pilight/pilight_usb_nano.hex:
[Jun 23 19:01:33:180412] pilight-flash: INFO: load data flash data from input file /etc/pilight/pilight_usb_nano.hex:
[Jun 23 19:01:33:181417] pilight-flash: INFO: input file /etc/pilight/pilight_usb_nano.hex auto detected as Intel Hex
[Jun 23 19:01:33:185048] pilight-flash: INFO: input file /etc/pilight/pilight_usb_nano.hex contains 4214 bytes
Reading | ################################################## | 100% 0.87s
[ Jun 23 19:01:34:52460] pilight-flash: INFO: verifying ...
[ Jun 23 19:01:34:52760] pilight-flash: INFO: 4214 bytes of flash verified
[ Jun 23 19:01:34:62337] pilight-flash: INFO: AVR lfuse reads as 0
[ Jun 23 19:01:34:70808] pilight-flash: INFO: AVR hfuse reads as 0
[ Jun 23 19:01:34:70918] pilight-flash: INFO: AVR fuses OK
[ Jun 23 19:01:34:76630] pilight-flash: INFO: Finished updating firmware
[ Jun 23 19:01:34:76769] pilight-flash: INFO: **** DONE UPD. FW ****
But LOG show
Code:
[Jun 23 19:03:26:651513] pilight-daemon: WARNING: could not sync FW values