[tihe]

Hi, I've successfully setup my pilight USB Nano Setup (I used the GPIO version before on my Raspberry Pi).

Unfortunately I need to send raw codes to control my Elro Flamingo Switches and I now have the following message in pilight.log:

ERROR: too many distinct pulses for pilight usb nano to send

I'm trying to send something like:
pilight-send -p raw --code="330 4940 330 1000 320 1010 970 360 320 1010 310 1010 970 370 320 1010 970 360 320 1010 970 370 960 370 960 360 320 1010 970 380 310 1020 300 1020 960 370 960 380 310 1020 960 370 310 1010 970 380 300 1030 950 380 300 1020 960 380 950 370 310 1020"

The same command did work perfect before with my GPIO setup.

Any advise or is this protocol implemented in pilight in the meantime? Thanks a lot
Tim