• 10 dec 2017: forum version update. In case of issues use this topic.
  • 30 nov 2017: pilight moved servers. In case of issues use this topic.
Hello There, Guest! Login Register


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Getting started with 433mhz / Kaku / Arduino nano
#1
Hello all,

I recently acquired the pilight approved 433Mhz RX/TX set and a Arduino nano, which I have flashed with the custom firmware and hooked up to my Pi 3. 

After getting pilight up and running (compiled it from source, since I am on CentOS) I found that I couldn't get receiving signals from my KaKu remotes working. Yet, when I fire up pilight-raw, I can catch data from the two remotes I own. 

When in normal / deamon mode, no data from the remotes is visible. Yet I assume that the Pi, Nano and RX/TX set is working fine, as I'm receiving data from some thermometer (probably my neighbour's).

Where should I look to make this work? My main remote is the KaKu ATMT-502.
 
Reply
  


Possibly Related Threads...
Thread Author Replies Views Last Post
  Real 433Mhz Remote is disturbed by pilight service henne111 2 156 10-06-2019, 06:18 PM
Last Post: wo_rasp
  pilight usb nano format conversion ettman8 2 452 07-14-2019, 08:32 AM
Last Post: curlymo
Question Pi 3+ & pilight & 433Mhz RXB6: no receiption hacklschorsch 3 776 02-05-2019, 10:37 PM
Last Post: hacklschorsch
Exclamation Brennenstuhl 433MHz RC C1 - pilight not work pitje87 0 569 10-31-2018, 12:38 PM
Last Post: pitje87
  433MHz sender - receiver problem EndruK 1 757 02-17-2018, 02:24 PM
Last Post: EndruK
  Does pilight listen to legacy 433MHz remotes? genfersee 2 719 02-14-2018, 09:21 AM
Last Post: genfersee
  Unable to get pilight working with kaku APA3-1500r MuadDev 0 597 02-11-2018, 03:51 PM
Last Post: MuadDev
  multiple 433mhz senders koos147 9 2,066 10-05-2017, 09:12 PM
Last Post: koos147
  Motion Sensors... (KAKU, Trust...), what now? haboku 1 713 09-27-2017, 02:26 PM
Last Post: pilino1234
  KAKU ALED-2009/ALED-2709 martijnhv 1 874 05-18-2017, 08:55 PM
Last Post: pilino1234

Forum Jump:


Browsing: 2 Guest(s)