Hello @all,
i have a big problem with the reach of the pilight hardware. Actual i have the following setup as AdHoc Network:
Server: Main Pilght deamon withpout hardware, wortking with Debian SID
AquaPi: Raspberry Pi 3 connected via WiFi
HomePi: Raspberry Pi 2 connected via LAN
FloorPi: Raspberry Pi 3 connected via WiFi
All three clients are working with the Full PCB-Kit here from the store, all devices have the latest stable pilight version with Raspian Stretch installed.
I guess, that only the first client, that connects to the server, will really sed a signal to the 433 MHz devices (most Intertechno).
But how can i verify this. It have tried to start one client alone, and have there nor problems with the reach of the signal.
But if i start the whole network, it is horrible. (All services stoped, start server, then the clients.) From one Client to the Intertechno ITS-1000 there are 100cm, and it does not work :-(
Do you have any ideas about this sitution?
Best Regards
Thomas Pfaffinger
i have a big problem with the reach of the pilight hardware. Actual i have the following setup as AdHoc Network:
Server: Main Pilght deamon withpout hardware, wortking with Debian SID
AquaPi: Raspberry Pi 3 connected via WiFi
HomePi: Raspberry Pi 2 connected via LAN
FloorPi: Raspberry Pi 3 connected via WiFi
All three clients are working with the Full PCB-Kit here from the store, all devices have the latest stable pilight version with Raspian Stretch installed.
I guess, that only the first client, that connects to the server, will really sed a signal to the 433 MHz devices (most Intertechno).
But how can i verify this. It have tried to start one client alone, and have there nor problems with the reach of the signal.
But if i start the whole network, it is horrible. (All services stoped, start server, then the clients.) From one Client to the Intertechno ITS-1000 there are 100cm, and it does not work :-(
Do you have any ideas about this sitution?
Best Regards
Thomas Pfaffinger