I got a simple multimeter at hand, so i go against ground and gpio17 (pin11) (which is defined in wiringpi as port0) right?
i'll give it a try. OK DONE
A) yes, i cycled the ID to just test if another ID will work - but it didn't.
B) repetition is on 12 - i set it up from 10
C) i got my multimeter on "DC measure" between DATA and GROUND - while i am sending commands there is a voltage around 0,6V.
i'll give it a try. OK DONE
A) yes, i cycled the ID to just test if another ID will work - but it didn't.
B) repetition is on 12 - i set it up from 10
C) i got my multimeter on "DC measure" between DATA and GROUND - while i am sending commands there is a voltage around 0,6V.